ACC Cables are a special kind of Pre-Trigger cable for use with the new FlexTT5 or the latest MultiMAX. Toggle Pre-Trigger on and off remotely with the MultiMAX. Required for remote camera triggering with a FlexTT5 if using E-TTL functions.
NOTE: An older mono motor drive cable and/or pre-release cable can be used instead of an -ACC cable with a FlexTT5 but you will not have E-TTL capability.
This cable contains a pre-trigger connection. When a remote zone is enabled on a MultiMAX, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When the remote zone is disabled, the camera will enter its normal sleep modes.
Compatible with cameras using Canon's N3 Remote Terminal:
Canon |
Canon |
Canon |
Kodak |
EOS-1D Mark III | EOS D30 |
EOS 20D |
DCS 560 |
EOS-1D Mark II N | EOS D60 |
EOS 30D |
DCS 520 |
EOS-1Ds Mark III | EOS 5D |
EOS 40D |
|
EOS D2000 | EOS 10D |
EOS-1D |
|
EOS-1Ds Mark II |
EOS-1V HS | EOS-1Ds | |
EOS-1D Mark II | EOS-3 |
EOS-1V |
Not for use with DCS Pro SLR/c